30 – English
1)
First change after 5 hours.
2)
When driving with a heavy load or when the ambient temperature is high, replace every 25 hours. Clean
every 25 hours if pre-filter is not fitted. Clean and replace the filter more often in dusty conditions.
3)
For daily use of the machine
lubrication should be conducted twice a week.
4)
Conducted by authorised service workshop.
MAINTENANCE
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
● = Described in these instructions.
❍ = Not described in these instructions.
Maintenance interval in
hours
Daily main-
tenance
before after
Weekly
3)
main-
tenance
At least
once a
year
25 50 100 300
PageMaintenance
• The engine is switched off.
• The ignition key is removed.
• The ignition cables are removed
from the plugs.
• The parking brake is applied.
• The cutting unit is disengaged.
Lubricate choke control 60 ●
Lubricate the chain in the frame tunnel 59 ●
Lubricate steering chain inside frame
tunnel 33 ●
Clean engine cooling air intake 39 ●●
Clean the air filter’s pre-cleaner
(foamed plastic) 37+38 ●●
Change engine oil
1)
62 ●●
1)
●
1)
Clean the air filter cartridge
2)
(paper filter) 37+38 ●●
Check/adjust cutting height setting 46 ●●
Check/adjust parking brake 34 ●●
Inspect flame guard/spark arrestor
(optional equipment) - ❍❍
Replace the engine oil filter
(every 200 hours) 64 ●●
Replace the engine’s hydraulic oil
filter (every 200 hours) 64 ●●
Clean/replace spark plugs 40 ●●
Replace fuel filter in pipe 35 ●●
Clean pulse-air filter 36 ●●
Clean the cooling flanges 36 ●●
Check engine valve clearance
4)
- ❍❍
Check to see whether the oil needs
changing
4)
or the filter
4)
(every 500 hours) in the gear box. - ❍❍
Replace the air filter pre-filter
(foamed plastic)
2)
37+38 ●●
Replace the air filter (paper filter)
2)
(every 200 hours) 37+38 ●●
Carry out 300 hour service
4)
- ❍❍
