15
M0021-01 • 05/21/14 • Hunter Fan Company
Step 8-7
Fan Speed
Low
Fan Off
Fan Speed
High
Fan Light
Fan Speed
Medium
8-1. Turn on electrical power to the fan.
8-2. To install or replace the battery, remove the door from
the back of the transmitter. Insert the battery into the
compartment, observing proper polarity placement.
Note: e remote must be paired before the fan will
operate.
8-3. Within 3 minutes of restoring power to the fan, press
both the Fan Off button and the High button for at
least 4 seconds. Your fan will turn on low to indicate
successful syncing. If it does not, turn off power to your
fan, wait 1 minute then try again. If using the transmitter
with multiple fans, repeat this process for each fan.
8-4 e remote has individual buttons for setting the fan
speed and light. Refer to the figure on the right.
Note: For best operation, start the fan by pressing high,
then select your desired speed.
8-5. e light button turns the light. Push the light button
again to turn off the light.
8-6. When necessary, replace the battery with a 12 V alkaline
battery.
8-7. You can mount the remote holder to any toggle switch
plate with the screws already in the switch plate. Or, you
can simply mount the remote holder on the wall.
Attention: Use the pull chain switch to set the fan speed
to the position BEFORE installation. Do not use pull
chain switch to change the fan speed after installation,
as damage to your fan or remote may result. e speed
of the fan should only be changed by the Hunter control.
Set the ceiling fan light kit to the ON position before
installation. e light level should only be changed by the
Hunter control.
8 • Operating the Remote Control and Mounting the Holder
• Press the Fan Off button for at least three seconds to
initiate the Safe-Exit Mode.
• The lights will ash for visual conrmation.
• The lights will stay on 50% brightness for 15 seconds and
then begin to dim. After a total of 30 seconds, the lights will
be completely off.
Note: For CFL lighting, the lights will stay on 100%
brightness for 30 seconds. After a total of 30 seconds, the
lights will be completely off.
The Safe-Exit Program gives you about 30
seconds of light when you turn the lights off
to exit the room before the lights go out. To
use Safe-Exit:
