12
42764-01 • 09/28/09 • Hunter Fan Company
7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Light Bulbs
(B10
Candelabra
Base 60 Watt
Maximum)
Metal Rod
Metal Disk
readed
Rod
Glass Bowl
Cover Plate
Finial
Light Bulbs
(B10 Candelabra
Base 25 Watt
Maximum)
Installing the Glass Bowl
7-8. First install B10 candelabra bulbs into the
sockets.
7-9. read the light and fan pull chains through
the hole in the center of the glass bowl. en,
thread the light pull chain through the hole in
the center of the cover plate.
7-10. read the fan pull chain through the
grommet hole in the side of the cover plate.
7-11. Place the cover plate up against the glass bowl.
Align the holes in the cover plate and glass
bowl.
7-12. read the light pull chain through the nial
and screw the nial onto the threaded rod end
until tight.
7-13. Attach the extra pull chains (included) to the
light and fan pull chains using the plastic
breakaway connector. (You may nd the
plastic breakaway connector on the end of the
extra chain.)
Note: In compliance with US federal energy
regulations, this ceiling fan contains
a device that restricts the light kit to
a maximum of 190 Watts. Exceeding
that limit or the marked limit on this
product may result in re hazard or
improper operation.
