G0594 Large Chipper/Shredder
-9-
Inventory
After all the parts have been removed from the
box, you should have the following items:
Inventory (Figure
3) Qty
A. Chipper/Shredder .......................................
1
B.
Wheel Assembly ......................................... 2
C. Hopper ........................................................
1
D. Funnel ......................................................... 1
E. Hopper Gasket ...........................................
1
F. Handles ......................................................
2
G. Leg .............................................................
1
H. Toolbox (Contents Not Shown) .................. 1
—Ear Protection ..................................1 Pair
—Safety Goggles ................................1 Pair
—Gloves ..............................................1 Pair
—Oil Funnel ...............................................
1
—Straight Blade Screwdriver .....................
1
—Wrench 13/15mm ....................................
1
—Wrench 12/14mm ....................................
1
—Spark plug Socket w/Handle
5
⁄8" ............ 1
Figure 3. Model G0594 inventory.
A
B
C
Hardware (Not Shown) Qty
• Hex Bolt M8-1.25 x 35 ...............................
4
• Rubber Grommets ......................................
4
• Phillips Head Screw M8-1.25 x 35 .............
4
• Fender Washers 8mm ................................
4
• Lock Nuts M8-1.25 ...................................
11
• Flat Washer 8mm .....................................
27
• Lock Washer 8mm ...................................
11
In the event that any nonproprietary parts are
missing (e.g. a nut or a washer), we would be
glad to replace them, or for the sake of expedi
-
ency, replacements can be obtained at your local
hardware store.
Assembly
The major components of this chipper/shredder
have been assembled at the factory. Some minor
assembly is required. The assembly process will
use all the parts and hardware listed in the inven
-
tory.
DO NOT attempt to start this machine until all
assembly has been completed. Serious personal
injury and damage to the machine could occur.
To assemble the chipper/shredder:
1. Tip the chipper/shredder over and remove
the four bolts shown in Figure
4. DO NOT
turn the chipper/shredder over once it is full
of oil and gas. The oil and gas will spill out
.
2. Attach the wheel assembly and the leg with
the bolts that were removed in Step 1
.
3. Set the chipper shredder upright and set the
hopper gasket around the chute as shown in
Figure
5.
Figure 4. Attaching the leg.
D
E
F
G
H
Wheel
Assembly
Bolts
Leg Bolts
Leg
