Grizzly G0677 Manual

A SERVICE OF

next previous

"'%"

<%+,,')EaVcZg$HVcYZg

The pressure rollers must be set below the

level of the sanding roller. If the pressure

rollers are even, or higher than the sanding

roller, the wood WILL be propelled from the

machine at a high rate of speed toward the

front of the machine. This could cause seri-

ous kickback injury.

To check the pressure roller height:

1. 9>H8DCC:8I I=: EA6C:G$H6C9:G

;GDBI=:EDL:GHDJG8:

Pressure Roller

Height

I]ZegZhhjgZgdaaZgh]VkZWZZchZiVii]Z[VXidgn!

Wji[dghV[Zin!ndjh]djaYkZg^[ni]Vii]ZnVgZhZi

WZadli]ZaZkZad[i]ZhVcY^c\gdaaZg#

2. EaVXZ V '% adc\ 'm) d[ jc^[dgb i]^X`cZhh

VXgdhhdcZh^YZd[i]ZiVWaZhd^iheVchWdi]

i]Z [gdci VcY gZVg egZhhjgZ gdaaZgh Vi i]Z

hVbZi^bZhZZFigure 20#

Figure 20.8]ZX`^c\egZhhjgZgdaaZg]Z^\]i#

3. L^i] i]Z V^g egZhhjgZ XdccZXiZY VcY i]Z

hVcY^c\WZai^chiVaaZYVcYiZch^dcZY!bVcj"

VaangV^hZi]ZiVWaZVcYkZg^[ni]Vii]ZWdVgY

idjX]ZhWdi]egZhhjgZgdaaZghWZ[dgZ^iidjX]"

Zhi]ZhVcY^c\WZai#

4. GZeZViStep 3dci]Zdi]Zgh^YZd[i]ZXdc"

kZndgiVWaZ#

Note:If the board did not touch both pressure

rollers before it touched the sanding belt on

either side, or if it was difficult to place the

board between the rollers and the table on in

Step 4, then the pressure rollers MUST be

adjusted before operation. See "Pressure

Rollers" on Page 49 for step-by-step instruc-

tions.