3307013
WARNING
FIRE AND EXPLOSION HAZARD
Improper grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition and
result in fire or explosion and serious injury.
D Ground the equipment and the object being sprayed/dispensed. See Grounding on page 4.
D Provide fresh air ventilation to avoid the buildup of flammable fumes from solvent or the fluid being
sprayed.
D Extinguish all the open flames or pilot lights in the spray/dispensing area.
D Electrically disconnect all the equipment in the spray/dispensing area.
D Keep the spray/dispensing area free of debris, including solvent, rags, and gasoline.
D Do not turn on or off any light switch in the spray/dispensing area while operating or if fumes are
present.
D Do not smoke in the spray/dispensing area.
D Do not operate a gasoline engine in the spray/dispensing area.
D If there is any static sparking while using the equipment, stop spraying/dispensing immediately.
Identify and correct the problem.
INSTRUCTIONS
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture, malfunction, or start unexpectedly and result
in a serious injury.
D This equipment is for professional use only.
D Read all the instruction manuals, tags, and labels before operating the equipment.
D Use the equipment only for its intended purpose. If you are uncertain about usage, call your Graco
distributor.
D Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
D Check the equipment daily. Repair or replace worn or damaged parts immediately.
D Do not exceed the maximum working pressure of the lowest rated system component. This equip-
ment has a 4050 psi (28.3 MPa, 283 bar) maximum working pressure.
D Use fluids that are compatible with the equipment wetted parts. See the Technical Data section of
all the equipment manuals. Read the fluid manufacturer’s warnings.
D Route the hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not
expose Graco hoses to temperatures above 180_F (82_C) or below –40_F (–40_C).
D Do not use the hoses to pull equipment.
D Wear hearing protection when operating this equipment.
D Comply with all applicable local, state, and national fire, electrical, and other safety regulations.
MOVING PARTS HAZARD
Moving parts, such as the air motor piston, can pinch or amputate fingers.
D Do not operate the equipment with the air motor plates removed.
D Keep clear of any moving parts when starting or operating the equipment.
