Installation Instructions
– Dishwasher must be level for proper
dish rack operation and wash performance.
• Make sure 1/2" minimum gap is maintained (see Figure T).
• Place level on door to check that the dishwasher is level side-
to-side. Place level on rack track inside tub to check that the
dishwasher is level front-to-back.
• If the dishwasher is not level, adjust the four leveling legs
Tip: Pull lower rack out, about halfway. Check to be sure the
rack does not roll forward or back into dishwasher. If the rack
rolls in either direction, the dishwasher must be leveled again.
• If door hits the tub, the dishwasher is not installed correctly.
Adjust leveling legs to align door to tub.
– After leveling, verify that the
dishwasher is still in the correct position shown in
STEP 11 SECURE DISHWASHER TO
In this step you will need
the 2 Phillips special head
screws set aside prior to
countertops are granite or
other materials that will not
2 to secure dishwasher at the sides.
Secure dishwasher to wood countertop
• Fasten the dishwasher to the underside of the countertop
with the 2 Phillips special head screws provided.
Secure dishwasher with side-mounting brackets
• Remove plug buttons (one on each side).
• Install screws through the dishwasher side mount bracket
and into the adjacent cabinet on each side. Reinstall plug
When step is complete, close dishwasher door and verify that
gap between countertop and top of dishwasher door is at
2514C
Screws
Plug Buttons
Granite Countertop
Countertop
Mounting
brackets
Side-Mounting
Bracket
