5
Switching the appliance on and off
You are recommended to clean the appliance before switch-
ing it on for the fi rst time (see “Cleaning”).
Connect the appliance to the mains – the
appliance is on.
To switch the appliance off : Keep ON/•
OFF button pressed for 3 sec. so that
the temperature display goes out.
To switch the appliance on : Press the •
ON/OFF button until the Display lights
up.
Operating and control elements
Temperature display
Temperature setting buttons
Audible warning on/off button
Ventilation on/off button
Child - proof lock
On/off button
Setting the temperature
To reduce the temperature : Press the button.
To increase the temperature : Press the button.
While you are entering the •
temperature, the set tem-
perature will fl ash on the
display.
You can change the set-•
tings in increments of 1
o
C
briefl y pressing the button
again.
The electronic controls will switch ove automatically about •
5 seconds after the last time you pressed the button, and
the actual temperature will be displayed.
Factory temperature setting is +12•
o
C.
If F1appears in the display, the appliance has a fault. Consult
your nearest customer service point.
Setting up
• Avoid locating the appliance in direct sunlight or near heat
sources such as an oven or a radiator.
• The fl oor should be level and even. You can compensate for
an uneven fl oor by adjusting the adjustable feet.
• Standard EN 378 specifi es that the room in which you
install your appliance must have a volume of 1 m³ per 8 g
of R600a refrigerant used in the appliance, so as to avoid
the formation of infl ammable gas/air mixtures in the room
where the appliance is located in the event of a leak in the
refrigerant circuit, The quantity of refrigerant used in your
appliance is indicated on the type plate on the inside of the
appliance.
• The appliance is set to operate within specifi c ambient
temperature limits according to its climate rating. These
temperature limits should not be exceeded. The correct
climate rating for your appliance is indicated on the type
plate.
SN - ST = +10 ° C to 38 °C
SN – T = +10 °C to +43 °C
