21
Using your cooktop
If there is a power failure
Models with auto-reignition (CG905DWAC)
The gas supply will be cut off, even if a burner is in use.
The cooktop cannot be used if there is a power failure. Wait until power is restored.
If a control dial is still turned on when the power is restored, the corresponding ‘Burner On’
indicator light will flash rapidly. Turn the burner off and light it again to resume cooking.
Models with flame failure protection (CG905DWFC, CG604DWFC)
You can still use your cooktop.
Light the burners by holding a match close to the side of the burner and pressing down then
turning the control dial to HIGH. Wait until the flame is burning evenly before adjusting.
If the flame is accidentally extinguished
Models with auto-reignition (CG905DWAC)
The auto-reignition system will detect this. The ignitors will spark and relight the
burner. If no flame is detected after about 5 seconds, the gas supply to the cooktop
will be cut off and the ‘Burner On’ indicator will flash slowly. In this event, turn the burner
off and relight it to resume cooking. See also ‘Troubleshooting’.
Models with flame failure protection(CG905DWFC, CG604DWFC)
The flame failure protection will automatically cut the gas supply to the burner off.
Turn the corresponding dial to O (OFF) and do not try to relight it for at least 1
minute (to allow the gas to disperse).
