DVS 510 Series • Remote Configuration and Control 55
Command
ASCII Command
(Host to Scaler)
Response
(Scaler to Host)
Additional Description
Input Selection
Video and audio
X! ! In X! • All ]
Select video and audio from input source
X!.
Video
X! & In X! • RGB ]
Select video from input source X!.
Audio
X! $ In X! • Aud ]
Select audio from input source X!.
NOTES: • When the DVS is in PIP mode, the input selection command affects the PIP window. In addition, all picture
controls and advanced input settings apply to the PIP input.
• Query commands (!, &, and $) return the full tagged response as seen in verbose modes 2 and 3. However,
responses that include only the X! variable are returned in verbose mode 0 or 1 (not tagged).
Input Video Format
Set video format
X! * X# \ Typ X! * X# ] Set input X! to video format X#.
View video format
X! \ X# ] View video type of input X!.
Input EDID (Inputs 5, 6, 8, and 10 only — DVI and VGA)
Specify an EDID value
E A X! * X2! EDID } Edid A X! * X2! ]
Set the EDID resolution and refresh rate
for input X! to X2!.
View EDID data
E A X! EDID } X2! ]
In verbose mode:
Edid A X! * X2! ]
View the EDID setting for input X!.
Auto-Image
Enable Auto-Image
X! * 1 A Img X! * 1 ] Perform Auto-Image on input X! when
it is selected or when a new signal is
applied.
Disable Auto-Image
X! * 0 A Img X! * 0 ] Turn off Auto-Image for input X!.
View Auto-Image
X! A X! ]
View the current Auto-Image setting for
input X!.
Execute an Auto-Image
A
Img ]
Perform an Auto-Image for the current
input.
Execute and ll
1 * A
Img 1 ]
Perform an Auto-Image on the current
input and fill the entire output display.
Execute and follow
2 * A
Img 2 ]
Perform an Auto-Image on the current
output and follow the aspect ratio of the
input.
NOTE: X! = Input selection 1 through 10
X# = Input video format 1 = RGB, 2 = YUVp/HDTV, 3 = RGBcvS, 4 = YUVi, 5 = S-video,
6 = Composite video, 7 = DVI
X2! = EDID resolution and refresh rate See the EDID resolution table on page 53 for the available values.
Command and Response Table for DVS 510 Series SIS Commands
