SD200-EU-EN V1.8 07/13
4
Operation
Battery Low Warning, Installation and Replacement
1. When the
icon appears in the display the batteries are weak and should be replaced.
However, in-spec. measurements may still be made for several hours, after low battery
indicator appears, before the instrument becomes inaccurate.
2. To replace or install batteries, remove the Philips head screw that secures the rear battery
cover and lift off the cover.
3. Replace the six AAA batteries (use alkaline heavy duty type), observing polarity.
4. Replace and secure the cover.
Connecting thermocouples
1. Insert the Type K thermocouple mini-connector plug into the mini-connector socket on the
bottom of the datalogger observing polarity (wide blade/narrow blade)
2. Up to three probes may be installed.
3. The temperature for inserted probes will be displayed T1, T2, T3 from top to bottom.
4. “-------“ will be displayed for open or unused inputs.
Datalogging
1. Open the left side door and insert a formatted SD card
Note: The SD card should be at least 1GB in capacity.
Note: Do not use memory cards formatted by other meters or cameras. Use the SD card
formatting procedure under the advanced features section of this manual to correctly
format the card.
Note: The internal clock must be set to the correct time. See the advanced features section of
this manual to set the clock.
Note: The default data structure uses a decimal point “.” as the numeric decimal indicator. See
the advanced features section of this manual to change this to a comma “,”.
Note: If the SD memory card is not installed, “EMPTY” will appear in the display.
Note: If the temperature probe is not installed, random numbers may appear in the data file.
Note: If the temperature probe is not installed, after data download the temperature units
symbol may not appear in the display.
Note: Displayed error messages:
The memory card is full or there is a problem with the card
The battery is low and datalogging is disabled
The SD card is not inserted
2. Press the LOGGER button for >2 seconds to begin logging. “DATALOGGER” will appear in the
display (between T2 and T3 displays) and the meter will beep each time the data is recorded (if
the beeper is enabled).
no
CArd
LobAt
CH-
CArd
