EX845-EU-EN v2.6 11/13
10
Bluetooth Communication
The meter includes a Bluetooth module designed to communicate with the Flir T/B200, T/B300,
T/B360, T/B400 or i/b60 cameras. The combination of a clamp meter and an IR camera is used for
analysis and documentation of temperature and current readings on single and three phase power
distribution panels.
Setup
1. Enable the EX845 bluetooth by pressing and holding the side Bluetooth SEND/Backlight button
for two seconds. On the second beep the bluetooth icon will appear in the display.
2. Pair the meter to the camera by following the “Pairing Bluetooth devices” section in the camera
manual.
3. Once paired, the data from the EX845 will be continuously displayed and updated on the
camera display.
Notes:
1. More than one meter can be paired with one camera to observe multiple legs in three phase
systems.
2. If a paired bluetooth device is removed from a camera list, perform a camera restore.
3. During initialization it can take up to 15 seconds to establish communication and display
results.
4. The data transmit function works in IR, Picture in Picture and Fusion modes, it does not work in
Digital camera mode.
5. If data stops appearing in the display, check that the bluetooth icon is active on the meter’s
display.
Image Editing
A single or series of readings can be applied to a single image by saving and entering the image
edit mode.
EX845
EX845 EX845 EX845
2
3
