Model 42580 Version 2.2 11/03
7
#6
Begin: 06-25-03
End: 06-25-03
Start: 13:55:00
Suspend: 14:00:00
Rate: 20
Start now? Yes
Datalog Configure Screen
Automatic Datalogging Mode
In the Auto Datalogging mode the Model 42580 can automatically measure and store 99
readings at a programmed sample rate. Four separate sets, numbered 5 through 8, can
hold 99 readings each. The function of the buttons in the LOG mode are:
Opens the automatic data storage mode, opens a set and clears the data
Selects the set # for recording or viewing.
Prints the stored records in a set.
Scroll up or down through the records in a set.
Stores Start time, Stop time and Log rate.
0… Stops a logging session
1 to Z Alpha-numeric label entry (9 buttons).
Selecting the Datalog Set
1. Press the button. A data set Configure
Screen will appear.
2. There are four sets available, numbered 5
through 8 (upper left hand corner).
3. Press the button to scroll through and
select one of the four sets.
Configuring the Datalogger
1. After selecting a set, use the
buttons to move through the fields and use the
alpha-numeric buttons to edit the parameters in
the fields shown in the diagram.
2. The programmable fields are:.
• Begin: Date when recording is to begin.
• End: Date when recording will end.
• Start: Time when recording will begin.
• Suspend: Time when recording will end.
• Rate: Interval of time between each reading (1 to 7200 seconds)
• Start now? Press while YES is highlighted to start recording at the date
and time programmed above.
Note that the datalogger will automatically record from the START time to the
SUSPEND time every day from the BEGIN day to the END day
