Problems and Solutions 143
Scan Quality Problems
Your scanned image is blurry or distorted.
■ Make sure the document is placed flat against the
scanner glass. If only part of the image is blurred, your
document may be wrinkled or warped.
■ Try scanning at a higher resolution, and make sure the
correct Image Type, Exposure, and Gamma setting are
selected in Epson Scan. Click the
Help button on the
Epson Scan window for details.
■ Clean the scanner glass with a soft, dry, lint-free cloth
(paper towels are not recommended). If the glass is still
not clean, use a small amount of glass cleaner on a soft cloth. Make sure you
wipe off any remaining cleaner. Don’t spray glass cleaner directly on the glass.
■ Make sure the Stylus Photo RX600 is not tilted or placed on an unstable or
uneven surface.
Your image is too dark.
■ Try adjusting the brightness with your application
software. Also check the brightness and contrast values
of your monitor.
■ The dark area around negative film is perceived as
white, altering the exposure of the scanning area and
causing your scans to appear darker. Set the correct
color by adjusting the border (marquee) so only your
image is selected. Then scan again. Click
Help in the
Epson Scan window for details.
■ Change the Display Gamma setting and check the Destination setting in
Epson Scan. Click
Help in the Epson Scan window for details.
SP RX600 Users Guide.book Page 143 Thursday, January 29, 2004 1:08 PM
