EPSON LX-300+
5/00 EPSON LX-300+
-
5
Safety Approvals
120 V
Safety standards UL 1950
CSA C22.2 No. 950
EMI FCC part 15 subpart B class B
CSA C108.8 class B
230 V
Safety standards EN 60950
EMI EN 55022 (CISPR pub. 22) class B
AS/NZS 3548 class B
Acoustic noise Approx. 49 dB (A) (ISO 7779 pattern)
CE Marking
230 V
Low Voltage Directive 73/23/EEC EN 60950
EMC Directive 89/336/EEC EN 55022 Class B
EN 61000-3-2
EN 61000-3-3
EN 50082-1
IEC 60801-2
IEC 60801-3
IEC 60801-4
Control Panel Buttons and Lights
Tear Off lights
f f
When continuous paper is in the tear-off position;
otherwise the lights indicate the selected font.
Tear Off (Font) button
❏
When the tractor is installed in the push position, advances
continuous paper to the tear-off position.
❏
Feeds continuous paper backward from the tear-off position
to the top-of-form position.
LF/FF button
❏
Feeds paper line by line when pressed and released.
❏
When held down, ejects a single sheet or advances
continuous paper to the next top-of-form position.
Load/Eject button
❏
Loads or ejects a single sheet of paper.
❏
When the tractor is installed in the push position, loads
continuous paper from the standby position or feeds
continuous paper backward to the standby position.
Paper Out light
❏
On when no paper is loaded in the selected paper source or
paper is not loaded correctly.
❏
Flashes when paper has not been fully ejected or a paper jam
has occurred.
❏
In Micro Adjust mode, selects the font indicated by the
Tear Off
lights.
Pause button
Stops printing temporarily, and resumes printing when pressed
again. When pressed for 3 seconds, turns on Micro Adjust
mode.
Pause light
❏
On when the printer is paused.
❏
Flashes when the printer is in the Micro Adjust mode or
when the print head has overheated.
Micro Adjust mode
When you hold down the
Pause
button for 3 seconds, the
printer enters the Micro Adjust mode. In this mode, you can
press the
LF/FF
D
and
Load/Eject
U
buttons to adjust the
top-of-form or tear-off position.
