2-24 Setup Rev. B
2.8.1 Items that can be set in the memory switch setting mode
The items that can be set in the memory switch setting mode are as follows.
❏ Autocutter settings (TM-L90 only)
❏ Paper selection / print density
❏ Serial communication conditions
• Baud Rate Setup
• data length, handshake, Parity
❏ Communication related
• Receive buffer size
• Receive error handling
• BUSY conditions
❏ Interface reset signal
• Parallel interface #31 pin: Selecting reset signal
• Serial interface #25 pin: Selecting reset signal
• Serial interface #6 pin: Selecting reset signal
❏ Paper width selection
❏ FEED button operational settings (TM-L90 peeler specification only)
❏ Label Settings
• Maximum length of automatic paper measurement
• With or without the function of feeding paper to the print starting position at power on
• Recovery from paper layout error
Note:
Turning off the power supply in the memory switch setting mode clears all settings. After performing the
complete operation, turn off the power using the correct procedure.
