Installing the Software for Windows 95 or Later
1. Make sure your printer is connected to the computer and that both are
turned off.
2. Turn on your computer, but leave your printer turned off. Make sure
Windows 95 is running (you should see the Windows Desktop icons).
3. Insert the EPSON Stylus Photo 700 CD-ROM or diskette 1 if you’re using
diskettes.
If Windows 95 launches the installation program automatically, you see the
EPSON Setup CD window. Go to step 4.
If it doesn’t launch automatically, click Start, select Run, and type D:\Setup700
(substitute the correct drive letter if it is not D). Then click OK. You see the
EPSON Setup CD window. Go to step 4.
If you are installing from diskettes, type A:\SETUP (substitute the correct drive
letter if it is not A). Then click OK. Go to step 5.
4. At the EPSON Setup CD window, make sure Initial Installation is selected and
click Next.
Note:
If you are installing the software for the first time, Initial Installation is
your only option. If you are reinstalling the software, you can select
Install EPSON Digital PhotoLab or Reinstall EPSON Printer Software.
If you click Exit Setup during the installation, you skip the EPSON Digital
PhotoLab installation and proceed directly to the printer software
installation.
8
Comoro+ GS Booklet 3/17/98, 4:35 PM12
