Chapter 2: Using the Printer A794 Owner’s Guide
March 19998
Printer Controls
Paper Feed
Button
LED (Green)
Reset
Button
Reset Button
Use the Reset Button to reset the printer in case of a jam or fault condition. When the
Reset Button is pressed, the printer goes through a startup routine as if it had been
turned off, then on again.
Paper Feed Button
Use the Paper Feed Button to advance the paper.
Use the Reset Button with the Paper Feed Button to print the test printout. To configure
the printer, set DIP switch 1 in the down (On) position and use the Reset Button with
the Paper Feed Button. Make sure to reset DIP switch 1 to the up (Off) position, when
you are done configuring the printer.
LED
The green LED shows the printer status by shining or flashing.
Status LED
Paper Is Low Flashes Slowly
Paper Is Out Flashes Quickly
Knife Jam Flashes Quickly then Slowly
