29
Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer.
The dishwasher is fitted with a number of alarm systems which can help you to
quickly determine the cause of any problems such as; the dishwasher will not start or
stops during operation, all push buttons are inoperative except for the On/Off push
button or the indicator light of the programme underway and one or more of the
phase indicator lights (washing, drying, end of programme) are flashing.
Press the On/off push button to switch off the dishwasher and carry out the
following suggested corrective actions listed below.
Important: If you call out an engineer to a fault listed below or to repair a fault
caused by incorrect use or installation a charge will be made, even if the
appliance is in guarantee.
Symptom Fault code Solution
The machine will not
●
The door has not been properly
start closed.
●
The plug is not properly inserted in
the power socket.
●
There is a power failure.
The machine does not “washing” phase
●
Ensure the water tap is open.
fill with water indicator light is
●
Ensure the mains water supply has
flashing not been cut off.
●
The inlet hose may be squashed or
bent. Reposition the hose.
●
The inlet hose may be blocked. Switch
off the water supply and clean the
filter.
The dishwasher will “drying” phase
●
The drain hose may be squashed or
not drain indicator light is bent. Reposition the hose.
flashing
●
The sink may be blocked. Clear any
blockages.
●
The drain hose extension is not
correct. Follow the instructions for
connecting to the waste.
●
There is no vent in the end of the
drain hose.
Protection against “drying” and “washing”
●
Close the water tap and contact the
flooding is active phase indicator lights Service Force Centre.
are flashing
General One or more phase
●
Switch off the dishwasher, switch it
indicator lights are back on and start the programme.
flashing If the alarm reappears, call the
Service Force Centre.
