Power Spot 700 II™
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page 24
Reed out internal temperature
Maximum cooling fan velocity
Automatic cooling fan control
Low cooling fan speed lamp off
Use the code for entering the calibration menu (for
authorized persons only)
Calibration of the color wheel 1
Calibration of the color wheel 2
Calibration of the gobo wheel 1
Calibration of the gobo wheel 2
Calibration of the gobo wheel 3
Calibration Shutter: Top side
Calibration Shutter: Bottom side
Calibration of the prism wheel
Calibration of the Pan-Offsets
Calibration of the Tilt-Offsets
Settings in the internal memory (super-user only)
Adjust Reset (wheels stand still after the reset)
Software version Tilt-board
Software version driver board 1
Software version driver board 2
Software version driver board 3
Use the code for entering the calibration menu (for
authorized persons only)
Coarse calibration of the color wheel 2
Coarse calibration of the color wheel 1
Call on the default function values
Pan/Tilt feedback (error correction) On/Off
8.1 Setting/Changing the DMX Address
After applying power to the POWER SPOT 700™ the LED will display the fixture’s
current DMX address immediately after the reset sequence. If the fixture is not
receiving a DMX signal the display will flash continuously.
To set or adjust a DMX address, please follow the procedure below:
1. Switch on the POWER SPOT 700™ and wait for the fixture reset process to
finished ('RESE' will flash in the LED while fixture is in reset mode).
