A SERVICE OF

logo

27
CS-352
Fuel lter
Fuel tank cap
0.65 mm (0.026 in.)
AIR FILTER
Check before every use.
Press hand guard forward and close choke.
Release the cylinder cover latches, and remove the
cylinder cover and air lter.
Brush off dust lightly, or clean with compressed air, or
replace the air lter.
Reinstall air lter and the cylinder cover, engage
latch.
CHECK FUEL SYSTEM
Check before every use.
After refueling, make sure fuel does not leak from
around fuel pipe, fuel grommet or fuel tank cap.
In case of fuel leakage there is a danger of re. Stop
using the machine immediately and request your
dealer to inspect or replace.
SPARK PLUG
Check periodically.
The standard spark gap is 0.65 mm (0.026 in.).
Correct the spark gap if it is wider or narrower than
the standard gap.
Fastening torque: 13 to 17 N·m
(130 to 170 in. lb.).
FUEL FILTER
Check periodically.
Do not allow dust to enter fuel tank.
A clogged lter will cause difculty in starting engine
or abnormalities in engine performance.
Pull the fuel lter out through fuel inlet port with a
piece of steel wire or the like.
When the lter is dirty, replace it.
When the inside of the fuel tank is dirty, rinsing the
tank out with gasoline can clean it.
Cylinder cover latch
Air lter
Cylinder cover
Cylinder cover latch
NOTE
FederalEPAregulationsrequireallmodelyear
2012andlatergasolinepoweredenginesproduced
forsaleintheUnitedStatestobeequippedwitha
speciallowpermeationfuelsupplyhosebetween
thecarburetorandfueltank.Whenservicingmodel
year2012andlaterequipment,onlyfuelsupply
hosescertiedbyEPAcanbeusedtoreplace
theoriginalequipmentsupplyhose.Finesupto
$37,500maybeenforcedforusinganun-certied
replacement part.