Getting Started
Section 1
DriveRack
™
5
This input network connection is used to receive information being sent from other units in the
DriveRack™ network link.
RS485 Control Thru Bus (RJ-45 connector type)
This Thru network connection is used to pass information to other units in the DriveRack™ net-
work link.
Termination LEDs
These LEDS indicate when network is properly terminated. The Green LED indicates that the
network has been correctly terminated.
Remote Controller In Connection
This DB-9 type input connection is used to send and receive information from the 480 Remote
DriveRack™ Unit.
Outputs 1-8 (Euroblock Connectors)
The output section of the 481 DriveRack™ offers eight electronically balanced Euroblock con-
nectors.
Inputs 1-4
The input section of the 481 DriveRack™ offers four electronically balanced Euroblock con-
nectors.
Ground Lift Switch
This switch (when pressed in), is used to lift the Pin one ground on either inputs 1 and 2 or 3
and 4.
PC Connection
This DB-9 type connection is used to send and receive information to and from the GUI inter-
face.
Program Up and Down
These program up and down buttons are used to scroll through the program menu of the 481.
Program Display
This program display is used to indicate the currently selected program of the 481.
ID Display
This ID display is used to indicate the current assigned identification of the 481. This identifi-
cation is essential for unit recognition when the 481 is used in a network system.
Control Bus LED
1.4 Front Panel (481)
DriveRack™ User Manual
