A SERVICE OF

logo

Open as PDF
next previous
16
To Adjust Blade Spring
•
The tension of the blade adjust spring may be altered
to permit the blade to tilt forward to bypass solid
obstructions. To change the spring tension, adjust
the nuts at upper end of the spring bolt. Turn the nuts
counterclockwise to relieve tension and clockwise to
increase tension. Refer to fi gure 19 on page 12.
To Adjust Blade Shoes
•
The blade shoes at the ends of blade may be raised
for close work on smooth surfaces or lowered to raise
the blade to work on rough or uneven areas. Make
sure both shoes are set evenly and that the nuts are
tightened securely. See fi gure 28.
SERVICE AND ADJUSTMENTS
FIGURE 28
To Adjust the Blade Pivot Lock Mechanism
•
If the blade will not unlock and pivot, the angle lock
bars are not disengaging from the slots in the pivot
plate. To correct, adjust the 5/16" hex jam nuts to draw
the end of the control cable back towards the cable
mount bracket. The less the threaded end of the cable
extends through the bracket, the more the angle lock
bars can retract to disengage from the slots in the
pivot plate. See fi gure 29.
FIGURE 29
Recommendations When Storing
•
When the snow blade is not being used, remove all
dirt and rust and touch up with paint.
•
Touch up bare metal with paint or apply a light coat of
grease or rust preventive.
•
Lubricate all pivot points and all points shown in fi gure
27, page 15 in the maintenance section.
•
Store in a dry area, protected from weather.
STORAGE
To Remove Blade From Tractor
•
Lower the blade head to the ground with the blade in
the center (straight ahead) position.
•
Remove the two clevis pins which fasten the
blade's hanger brackets to the tractor's mower deck
suspension brackets (or frame brackets). See fi gure
11 on page 10.
•
Remove the clevis pin that fastens the blade's rear
mounting bracket to the tractor's drawbar and drop the
rear of the blade frame to the ground. See fi gure 10
on page 10.
•
Remove the frame brackets (if used). See fi gure 3 on
page 6.
•
Back the tractor off of the blade assembly.
TROUBLESHOOTING
CAUSE
Lift mechanism is binding
Handle tube is binding on lift rod.
Lock mechanism is out of adjustment
Lock mechanism is out of adjustment
and is not disengaging.
PROBLEM
Blade is diffi cult to raise.
Blade is diffi cult to pivot.
Blade will not unlock to pivot.
CORRECTION
Lubricate pivot points as shown in
fi gure 27 on page 15.
Lubricate lift handle rod as instructed
in fi gure 27 on page 15.
Refer to the Service and Adjustments
Refer to the Service and Adjustments
section on this page.
CABLE MOUNT BRACKET
5/16" HEX
JAM NUT
CONTROL
CABLE
5/16" HEX
JAM NUT
BLADE SHOE