3-3
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager
OL-10008-01
Chapter 3 Setting Up the Cisco Unified IP Phone
Before You Begin
Cisco Unified CallManager Configuration
The Cisco Unified IP Phone requires Cisco Unified CallManager to handle call
processing. Refer to Cisco Unified CallManager Administration Guide or
context-sensitive help in the Cisco Unified CallManager application to ensure
that Cisco Unified CallManager is set up properly to manage the phone and to
properly route and process calls.
If you plan to use auto-registration, verify that it is enabled and properly
configured in Cisco Unified CallManager before connecting any
Cisco Unified IP Phone to the network. For information about enabling and
configuring auto-registration, refer to Cisco Unified CallManager Administration
Guide. Also, see the “Adding Phones to the Cisco Unified CallManager
Database” section on page 2-11.
You must use Cisco Unified CallManager to configure and assign features to the
Cisco Unified IP Phones. See the “Telephony Features Available for the Phone”
section on page 5-2 for details.
In Cisco Unified CallManager, you can add users to the database and associate
them with specific phones. In this way, users gain access to web pages that allow
them to configure items such as call forwarding, speed dialing, and voice
messaging system options. See the “Adding Users to Cisco Unified CallManager”
section on page 5-16 for details.
Safety
Review the following warnings before installing the
Cisco Unified IP Phones 7906G and 7911G. To see translations of these
warnings, refer to the Regulatory Compliance and Safety Information for the
Cisco Unified IP Phone 7900 Series document that accompanied this device.
Warning
Read the installation instructions before connecting the system to the power
source.
Statement 1004
Warning
Only trained and qualified personnel should be allowed to install or replace this
equipment.
Statement 49
