ÉPIX™ Drive 640 User Manual
Page 4 of 14
Notes
Read all the following Safety Notes before working with this product.
These notes
include important information about the installation, usage,
and maintenance of this product.
There are no user-serviceable parts in this product. Any reference to
servicing in this User Manual applies only to properly certified
CHAUVET® technicians. Do not open the housing or attempt any
repairs unless you are certified by CHAUVET®.
Please refer to all applicable local codes and regulations for proper
installation of this product.
Safety
• Always disconnect this product from its power source before servicing.
• Always connect this product to a grounded circuit to avoid the risk of
electrocution.
• Do not touch this product’s housing during operation
very hot.
Rigging
• This product is for indoor use only! To prevent risk of fire or shock, do
not expose this product to rain or moisture.
• Make sure there are no flammable materials close to this product while
it is operating.
• When hanging this product, always secure to a fastening device using a
safety chain/cable (not included).
Wiring
• Always make sure you are connecting this product to the proper
voltage, as per the Technical Specifications in this manual or on the
product’s specification label.
• Never connect this product to a dimmer pack or rheostat.
• Never disconnect this product by pulling or tugging on the power
cable.
• Do not operate this product if you see damage on the housing, I/O
ports, or cables. Have the damaged parts replaced by an authorized
technician at once.
• Do not cover the ventilation slots when operating to avoid internal
overheating.
• The maximum ambient temperature is 104° F (40° C). Do not operate
this product at a higher temperature.
• In case of a serious operating problem, stop using this product
immediately!
In the unlikely event that your CHAUVET® product may require service,
contact CHAUVET® Technical Support.
