Page 11
7
• Insert two #10-24 X 3-1/2” screws into handle and place
spacers and fiber washer onto screws on other side of handle.
• Place the handle assembly into the holes on the front of the
smoker chamber door and secure with two #10-24 flange nuts.
Tighten flange nuts until bolt head is flush with handle.
• Repeat on firebox door.
• Assemble spring handle by sliding spring through handle rod
until spring is in the middle of handle rod as shown in inset.
• Insert spring handle through holes on the side of firebox and
secure with two 1/4-20 flange nuts.
Fully tighten all screws and nuts.
o #10-24
lan
e nuts.
h with handle.
throu
h handle rod
as shown in inse
side o
irebox and
Screw
Handle
Spacer
Fiber
Washer
Nut
Nut
Spring
Handle
Firebox
Handle Rod
Spring
8
• Remove wing nut from temperature gauge.
• Insert temperature gauge though smoker chamber lid hole
above handle securing it from the underside with the wing
nut removed aligning the gauge settings before fully
tightening.
• Insert logo plate though smoker chamber lid holes to the
right of the handle, securing it from the underside of the lid
with two logo clips.
er lid holes to the
underside o
the lid
Temperature
Gauge
Logo Plate
Logo Clips
Wing
Screw
