7
8
16 • 10201597-50
• Insert 1/4-20x1/2” Hex Head Bolt and flat washer through the top smoker body, in the center of the damper holes as shown.(A)
• Insert the damper as shown. (B)
• Place the 1/4” flat washer onto bolt and thread the 1/4-20 nut on to the bolt. Tighten the nut sufficiently to allow the damper to move. (B)
• Damper is shown properly installed in figure C.
• Install the side handles with 1/4-20X3/4” screws and 1/4-20 Keps nuts as shown (D)
• NOTE: If the handle springs are not installed on the handle rod, Install them per inset E.
• Install Drawer Handle using 2 - 1/4-20x 3/4”screws and 2 1/4-20 Keps nuts. Tighten securely.
• Place the Water Pan onto the drawer rack as shown.
• Slide the Drawer, with Water Pan, into the Smoker body.
Qty: 1
#1/4-20 Nut
Qty: 1
#1/4-20x1/2"
Hex Head Bolt
Qty: 2
#1/4 Flat
Washer
A
B
C
Damper shown
installed
Insert 1/4-20X1/2” bolt
and flat washer into bolt hole
Insert damper handle through
damper hole as shown
Install Side Handles with 1/4-20X3/4”
bolts and 1/4-20 Keps nuts as shown.
Qty: 4
#1/4-20x3/4”
Combo truss
head screw
Qty: 4
#1/4-20 Keps Nut
Handle Rod
Spring
E
1/4-20X3/4” screws
1/4-20 Keps nuts
D
Qty: 2
#1/4-20x3/4"
Combo truss
head screw
Qty: 2
#1/4-20 Keps Nut
1/4-20x3/4” bolts
1/4-20 Keps nuts
Smoker Drawer
Water Pan
Smoker Drawer
Water Pan Frame
CAUTION: THE DAMPER HANDLE
WILL BE HOT WHILE COOKING!
WEAR AN INSULATED OVEN MITT
WHEN MAKING ADJUSTMENTS!
