Troubleshooting Guide
II
III
I J
If there is a problem, refer to this Troubleshooting Guide.
The Speed
lite
does not fire.
• The batteries are installed
in
the wrong orientation.
..
Install the batteries
in
the correct orientation. (p.8)
• The Speedlite's internal batteries are exhausted.
~
If the flash recycling time takes 30 sec. or longer, replace the
batteries. (p.8)
~
Install the Speedlite's internal batteries even when you use an
external power source. (p.8)
The Speed
lite
is
not attached securely to the camera.
• ' Attach the Speedlite's mounting foot securely to the camera. (p.9)
• The electrical contacts of the Speed
lite
and camera are dirty.
• Clean the contacts. (p.9)
The slave unit does not fire.
• The slave's wireless mode
is
not set to
<a,'·S9_>.
~'
Set it to <a,,·S!)_>. (p.36)
• The slave unit{s)
is
not positioned properly.
~
Place the slave unit within the master unit's transmission range.
(p.38)
.'
Point the slave unit(s)'s sensor toward the master unit. (p.38)
The power turns off by itself.
• After 90 sec. of idle operation, auto power off took effect.
Press the shutter button halfway or press the test firing button.
(p.10)
The entire LCD panel blinks.
• The wide panel has been pulled out for bounce flash.
~'
Retract the wide panel. (p.20)
50
