A SERVICE OF

logo

Setting up the sewing computer14
Inserting the bobbin
... it lies in the T-shaped slit at
the end of the spring.
The bobbin must turn clock-
wise when thread is pulled.
Insert the bobbin
Insert the bobbin so that the
thread runs clockwise.
Pull the thread counter clock-
wise into the slot.
Pull the thread to the left
under the spring until ...
Removing the needle
raise the needle
turn power switch to 0
lower the presser foot
loosen the needle clamp screw
pull the needle down to remove
Inserting the needle
flat side of needle to the back
insert the needle as far as it will go
tighten the needle clamp screw
Changing the needle
Refer to the safety instruction!
activa 125 (GB) 4.12.2002 14:16 Uhr Seite 14
030595.50.04_0201_a125_EN