H46
© 2008 AS America Inc.
HERITAGE™ 5' x 42"
WHIRLPOOL AND BATHING POOL
HIGH GLOSS
Revised 2/08
NOTES:
BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND, OR PENINSULA TYPE INSTALLATION. SUMP
OF BATH IS SUPPORTED BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. ENCLOSING MATERIAL BY OTHERS.
■ REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.
OPTIONAL APRON 9160.2800 and GRAB BAR KIT AVAILABLE AND MUST BE ORDERED SEPARATELY.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.
● IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR INTERFERENCE WITH
CIRCULATING SYSTEM PIPING, DRAIN OVERFLOW. MOUNTING HOLES DRILLED BY INSTALLER.
SUPPLY PIPING NOT INCLUDED.
IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1.
These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.
1524mm
(60)
INTEGRAL
FITTING DECK
762mm
(30)
1067mm
(42)
OUTLINE OF CUTOUT
1486mm x 1029mm
(58-1/2 x 40-1/2)
PROVIDE ACCESS
TO PUMP FOR
SERVICE ON ALL
INSTALLATIONS
C/L OF
DRAIN
178mm x 381mm
(7 x 15)
FLOOR
CUTOUT
19mm
(3/4)
PUMP
305mm
(12)
152mm
(6)
1-1/2 N.P.T.
THREADS
ROUGH
FLOOR
INTEGRAL
FEET
SUPPORT
1-1/2 O.D.
TAILPIECE
546mm
(21-1/2)
495mm
(19-1/2)
133mm
(5-1/4)
64mm
(2-1/2)
121mm
(4-3/4)
LEVELING STRINGER
NOT FOR SUPPORT
C/L OF
OVERFLOW
51mm(2)
SAFE-T-HEATER
REMOVABLE
BLANK
GENERAL SPECIFICATIONS FOR 2805 WHIRLPOOL
60 x 42 x 21-1/2 In. (1524 x 1067 x 546mm)
130 Lbs. (59 Kg.)
689 Lbs. (310 Kg.)
64 Gal. (243 L)
52 Gal. (197 L)
43 x 22 In. (1092 x 559mm)
55 x 35-1/2 In. (1397 x 902mm)
15 In. (381mm)
39 Lbs./Sq.Ft. (191 Kgs./Sq.m)
27.8
47.4
2.1 HP, 15.6 AMPS ,120V.SYSTEM II PUMP
WHIRLPOOL ELECTRICAL SPECIFICATIONS
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT
3
)
1524mm
(60)
INTEGRAL
FITTING DECK
762mm
(30)
1067mm
(42)
OUTLINE OF CUTOUT
1486mm x 1029mm
(58-1/2 x 40-1/2)
C/L OF
DRAIN
178mm x 381mm
(7 x 15)
FLOOR
CUTOUT
19mm
(3/4)
305mm
(12)
152mm
(6)
1-1/2 N.P.T.
THREADS
ROUGH
FLOOR
INTEGRAL
FEET
SUPPORT
1-1/2 O.D.
TAILPIECE
546mm
(21-1/2)
495mm
(19-1/2)
133mm
(5-1/4)
64mm
(2-1/2)
121mm
(4-3/4)
LEVELING STRINGER
NOT FOR SUPPORT
C/L OF
OVERFLOW
51mm(2)
GENERAL SPECIFICATIONS FOR 2805 BATHING POOL
60 x 42 x 21-1/2 In. (1524 x 1067 x 546mm)
115 Lbs. (52 Kg.)
674 Lbs. (306 Kg.)
64 Gal. (243 L)
43 x 22 In. (1092 x 559mm)
55 x 35-1/2 In. (1397 x 902 mm)
15 In. (381mm)
39 Lbs./Sq.Ft. (191 Kgs./Sq.m)
27.8
47.4
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT
3
)
