BATH FILLER SUPPLIES
MODEL 9117.012
DESCRIPTION
DO NOT USE PIPE DOPE FOR THREADED CONNECTIONS AS FINISH DETERIORATION MAY RESULT.
INSTALLATION MUST COMPLY WITH APPLICABLE LOCAL PLUMBING/BUILDING CODES
INSTALLATION
INSTRUCTIONS
To ensure this product is installed properly, please
read these instructions carefully before you begin.
Bath Filler Supplies, Model 9117.012, includes 6” deck mount
supply adapters, riser tubes, couplings, shutoff valves, and all
fittings and supports needed to install and connect the 9116
Series Bath Filler to the water supplies.
Adjust centerline spacing of supports and water supply lines
as needed to accommodate American Standard 9116 Series
Bath Filler. Please refer to Bath Filler Installation Instructions
for this dimension.
Hacksaw/Tubing Cutter
Phillips Screwdriver
Slotted-Head Screwdriver
Tape Measure
Pipe
Wrench
Level
Plumb Bob
Teflon Tape (pipe sealant) or
Teflon Based Pipe Sealant
Clear Silicone Sealant
Drill, misc. bits
1" Hole Saw or Spade Bit
Open-end Adjustable
Wrench Torpedo
RECOMMENDED TOOLS AND MATERIALS
752870-100 Rev. A
Product names listed herein are trademarks of American Standard Inc.
© American Standard Inc. 2004
Step 1. Locate and mark correct centerline dimension for Bath Filler on bath deck per roughing-in dimensions on installation instructions supplied
with bath. (Plan Ahead, be sure that floor joists do not interfere with water supply lines or drain connections!)
Step 2. Extend hole centerlines from bath to floor using Plumb Bob.
Step 3. Drill 1" diameter holes for supply risers at locations marked in step 2.
NOTE: Water supplies are primarily factory assembled and water tested.
DO NOT
attempt to disassemble supplies, as surface may be
damaged and warranty will be void.
Step 4. Assemble floor escutcheons and base flange to short pipe on supply risers. Insert supply risers into floor mounting holes (with shutoff valves
facing outward) and loosely install flat washers and locknuts on pipe nipples from beneath floor.
GASKET
SUPPLY
RISER
FLOOR
ESCUTCHEON
DECK MOUNT
WASHER
VALVE
HANDLE
COVER
SCREW
FLANGE
NUT
UNION
FLOOR
FLANGE
UNION
NIPPLE
WASHER
FLANGE
NUT
FLANGE
SCREWS
5" DECK MOUNT
ADAPTER
Assembly
INSTALLATION PROCEDURES
