17
HOW TO CLEAN AND MAINTAIN YOUR AIR PURIFIER
1) A. With the front of the unit facing up, pull the lower end of the inlet grill.
(A350, A375UV)
B. Release the inlet grill by pressing from the locking switch and pull forward.
(T300, T100)
2) Remove the inlet grill from the unit.
3) A. Remove the HEPA lter by lifting the pull string. (A350, A375UV)
B. Grasp the right and left frame of the lters through the recess on the side of the
lter enclosure, and remove the lters. (T300, T100)
4) The pre-lter can be removed from the HEPA lter for cleaning, after cleaning the
pre-lter can be reused.
5) Clean the pre-lter after every 200-300 hours of use, or you can clean it accord
-ing to the air condition on the room. The pre-lter can be cleaned with a vacuum
or by washing.
6) Clean the inlet grill after 200 - 300 hours use, or you can clean it according to
TROUBLE SHOOTING
Problem Reason Solution
Unit will not operate
1) ON/OFF button has not been pressed.
2) Unit is unplugged.
3) The inlet grill has not been installed or
locked into place.
1) Press the ON/OFF button.
2) Check to make sure the unit is plugged in.
3) Check to make sure the lters are prop-
erly installed and the inlet grill is installed
and locked into place.
Reduce air ow or
poor ltering
1) The inlet or outlet grill may be blocked
2) The HEPA lter may be clogged
1) Make sure nothing is in front or at the
back of the air purier.
2) Check the lter and the HEPA lter re-
placement indicator and replace if necessary.
The HEPA indication
bars are still lit after
the replaced
1) The unit has not been reset.
1) Turn on the unit, then insert a small object
(such as a pin or a paper clip) into the hole
marked RESET until the indicator is off.
Warning: Prior to cleaning or other maintenence, this appliance must be
unplugged from the power supply.
