7
Installing Your Wireless AP
Installing the Wireless AP
Your Wireless AP can fit into your WLAN in multiple ways. It can
be connected to a hub or switch on your network, a router on your
network, or a network adapter that’s installed in a computer on
your network.
To install the Wireless AP:
1 Use the mounting screws to secure the Access Point in place, if
desired.
2 Connect the Ethernet cable to the LAN port on the Access Point.
3 Depending on your network configuration, connect the other
end of the Ethernet cable to the LAN port on:
■ a hub or switch on your network.
■ a router on your network.
■ a network card installed in another computer on your
network.
4 Connect the power adapter to the DC-IN port on the Access
Point (as shown in Step 2 on page 7), and plug it into a power
outlet.
5 Raise the Access Point’s antennas.
Your Wireless AP is installed. See Installing the Wireless Access Point
Utility on page 8 to continue with your next Installation task.
Step 2:
Connect LAN.
Step 4:
Connect power.
