Setup for 230Kbps 3-31
4 From the Main menu, select Control Panel, then select
Network.
The Network Settings dialog box appears.
5 Click Configure.
The Remote Access Setup dialog box appears.
6 Click Configure.
7 Select 3ComImpact IQ 230K.
8 Click OK.
9 Change the setting of your application program to 230400
bps.
This completes the procedure to change the baud rate to
230.4 Kbps for Windows NT 3.5.1.
Refer to Chapter 5, “Advanced Configuration,” to review the
default settings and ensure that they reflect your preferences.
If you prefer not to change the default settings, then go on
to Chapter 7, “Placing and Receiving Calls”.
Setting up 230K for Windows 95 and Windows NT 4.0
These instructions require prior installation of the impact.inf
driver, which is installed as part of the initial setup procedure.
Refer to “Setup Using Windows 95” or “Setup for Windows NT
4.0” earlier in this chapter for assistance.
1 Ensure that your computer’s COM port and
communications software support 230.4 Kbps.
For instructions on sending AT commands, refer to the section
“Changing the Parameter Settings” on page 5-4.
2 Using terminal emulation software (such as
HyperTerminal) send the command
AT $B 230400 to the
