Filter
Top Products
–
9
–
EN
HOOK UPS
Connecting to an Amplifier Equipped with Digital Input Jacks such as MD deck or DAT deck
Use an audio coaxial digital cable (not included) for the audio connections. Connect to an amplifier equipped with digital input
jacks such as MD Deck or Dat Deck as shown below.
DIGITAL
AUDIO
OUT
ANALOG
AUDIO OUT
VIDEO
OUT
S-VIDEO
OUT
R
L
COAXIAL
To COAXIAL DIGITAL
AUDIO OUT jack
To VIDEO INPUT jackTo VIDEO OUT jack
To S-VIDEO
INPUT jack
To S-VIDEO OUT jack
To COAXIAL DIGITAL
AUDIO INPUT jack
A/V-compatible
or
wide screen TV
Amplifier equipped with digital
input jacks, MD deck,
DAT deck, etc.
or
[Fig. 6]
NOTES:
• The audio source on a disc in a 5.1 channel Dolby Digital surround format cannot be recorded as digital sound by an MD
or DAT deck.
• Set Dolby Digital to off for audio output in the setup mode. Playing a DVD using incorrect settings may generate noise
distortion, and may also damage the speakers.(See page 14 to set ON for Dolby Digital)
HOW TO CONNECT TO A TV WITHOUT AUDIO/VIDEO INPUT JACKS
If your TV does not have RCA type audio and video input jacks it is still possible to connect this DVD player to your TV’s 75-
ohm coaxial antenna terminal using a commercially available Stereo Audio/Video RF Modulator. Connect the audio and
video outputs of the DVD player to the audio and video inputs on the RF Modulator, and then connect the coaxial output of
the RF Modulator (usually marked “TO TV”) to the 75 ohm coaxial antenna terminal on your TV. Follow the instruction
supplied with the RF Modulator for more details.
If your TV’s 75 ohm coaxial antenna terminal is already occupied by an antenna or cable box connection, remove that cable
from your TV’s antenna terminal and reconnect it to the coaxial antenna input terminal of the RF Modulator (usually marked
“ANT IN”), then connect the RF modulator to your TV’s antenna terminal as described above.
NOTE
• The picture quality from DVD discs will not be as good if the DVD player is connected to the TV’s antenna terminal
through an RF Modulator.
NOTES:
• If output Dolby Digital audio, connect to a Dolby Digital decoder, and set Dolby Digital to ON for audio output in the setup
mode.
• Unless connected to a Dolby Digital decoder, set Dolby Digital to OFF for audio output in the setup mode. Playing a DVD
using incorrect settings may generate noise distortion, and may also damage the speakers.
Connecting to a Dolby Digital decoder
If using this DVD player to playback a DVD in a 5.1 channel Dolby Digital surround, the DVD player outputs a Dolby Digital
data stream from its COAXIAL DIGITAL AUDIO OUT jack. By hooking the player up to a Dolby Digital decoder, you can enjoy
a more convincing, realistic ambience with powerful and high-quality surround sound of a professional standard such as can
be heard in movie theaters.
Use an audio coaxial digital cables (not included) for the audio connections.
DIGITAL
AUDIO
OUT
ANALOG
AUDIO OUT
VIDEO
OUT
S-VIDEO
OUT
R
L
COAXIAL
To COAXIAL
DIGITAL AUDIO
OUT jack
To VIDEO INPUT jackTo VIDEO OUT jack
To S-VIDEO
INPUT jack
To S-VIDEO
OUT jack
To COAXIAL DIGITAL
AUDIO INPUT jack
A/V-compatible
or
wide screen TV
Front
speaker
(left)
Center speaker
Front
speaker
(right)
Surround
speaker
(left)
Surround
speaker
(right)
Subwoofer
Dolby Digital
decoder
or
[Fig. 7]
E5791UD.QX3 03.1.27 2:09 PM Page 9