Filter
Top Products
(11)
PRIORITY SCAN CHANNEL
To set a priority scan channel:
PRI
1. Press momentarily four times while in
standby mode to enter Priority Scan Channel
mode. The current priority channel will be
indicated.
2. Press or key to increase or decrease the
desired channel number.
3. Press three times to confirm and exit
to standby mode. will be displayed when a
priority channel has been selected.
select/
select/
BCL (Busy Channel Lockout) ON/OFF
SCAN CHANNEL MEMORY
BCL is used when CTCSS or DCS is selected to prevent transmission when
the uh064sx detects a transmission from another unit using the same CTCSS
or DCS code.
1. Press momentarily five times while in
standby mode to enter mode.
The current BCL status will be indicated.
2. Press or key to select (on) or (oF).
3. Press two times to confirm and exit to
standby mode. willbe displayed when BCL on
has been selected.
1. Select desired channel using key and or key.
2. Press and hold key. will appear on the display.
Repeat steps 1 and 2 to clear channel from Scan Channel Memory.
To set BCL ON/OFF:
BCL ON/OFF
ON OFF
BCL
To store a channel into Scan Channel Memory:
MEM
select/
select/
ch/txp
mem/SCN