Filter
Top Products
14
UNIDEN Model UH013 UHF CB Radio
Operation
Searching
Searching checks every frequency within the Band. If an active channel is located the UH013 will stop on that
channel until 2 seconds after the transmission ends, then continue.
Search Hold
1. To stop the search, press at any time. HLD is displayed.
2. To continue, press again.
Skip
Changing the Search Band
While searching press and hold for 2 seconds. The UH013 will move to the next band.
Scanning Stored Frequencies
You may store up to 40 frequencies from any band into memory and then only scan those frequencies
for activity.
1. Select Wide Band Scanning (see page 13).
2. Press .
3. To stop the Scan, press at any time. HLD is displayed.
4. To continue, press again.
Programming Scan Frequencies
1. Select wide band scanning (see page 13).
2. Press and turn the Channel selector to choose a memory location (41 - 80).
3. Press to approach the desired frequency.
4. Turn the Channel Selector to stop searching and fine tune to the exact frequency.
5. Press to store the selected frequency.
SCAN
NOTE
MEM
SRCH
SCAN
SRCH
SRCH
SCAN
SCAN
SRCH
If a particular frequency continues to interrupt searching, you can set your radio to skip the frequency by pressing
the button during search hold (you may skip up to 10 frequencies). To cancel Skip, press again
while search holding at the desired frequency. To cancel all Skipped frequencies, press and hold
for 2 seconds during search hold.
Repeat procedure as necessary to programme the other memory locations.
INST
INST
Rotary
Channel
Selector
CAL TSQ DUP
TX
WS
SLCT
STORE
INST
SQT
CTCSS
SET/SKIP
SCAN
MEM
SRCH
DUP
OS/GS
TSQ
SLT
SLT
MHz
S/RF
MON SCN GS BCL INS
SRC HLD SQT M
VOL
Deleting stored frequencies
1. Select the desired memory location.
2. Press and hold for 2 seconds to delete the selected frequency.
INST
SCAN