Filter
Top Products
user manual
QLight
series
TQ-440SP manual
page 12
Mounting and Fixing
A versatile range of mounting hardware is available for the TQ-440SP that allows it to be used in a
variety of ways, in either mobile applications or permanent installations.
A top hat stand type fitting
A top hat stand type fittingA top hat stand type fitting
A top hat stand type fitting is mounted in the base of the cabinet
for use with 35mm diameter loudspeaker stands with a load rating
of at least 37kgs (82lbs).
This top hat fitting may also be used to mount the TQ-440SP
cabinet at the correct height above the complementary TQ-425SP
subwoofer using a straight 35mm pole.
Internal metric threaded rigging points
Internal metric threaded rigging pointsInternal metric threaded rigging points
Internal metric threaded rigging points are provided
in several locations on the cabinet – on the top, bottom
and sides - enabling it to be flown using standard M10
shoulder eyebolts (available from Turbosound).
Downward inclination of the enclosure can be adjusted
using an additional rigging point on the rear of the
cabinet.
Side
SideSide
Side-
--
-mounted flying strips
mounted flying stripsmounted flying strips
mounted flying strips can be fitted to the sides of
the enclosure by removing the countersunk bolts on
the top and sides of the cabinet and replacing them
with the M10 bolts provided with the hardware. Two
FF-440 flying strips are required for each enclosure.
This method offers a simple and cost effective method
of flying single or multiple TQ-440SP enclosures, with
the load being taken through the steel strips rather
than through the woodwork of the enclosure.
Enclosures may be arranged in a vertical column by
coupling the flying strips together using QL-75
quicklinks or shackles.