Filter
Top Products
user manual
TL series
TL series manual
page 11
MOUNTING AND FIXING
Rigging hardware
A versatile range of mounting hardware is available
that allows enclosures to be used in a variety of
ways, in either mobile sound reinforcement
applications or permanent installations.
A pole mount / tripod stand fitting
A pole mount / tripod stand fittingA pole mount / tripod stand fitting
A pole mount / tripod stand fitting is fitted to the
bottom of the TL-1201 and TL-1501 full range
cabinets. Use this pole mount facility with either
optional Turbosound PA-100 35mm diameter poles,
or conventional loudspeaker tripod stands. Doing so
will raise the TL-1201 or TL-1501 loudspeaker above
the heads of an audience, providing better sound
coverage from a single enclosure. A matching pole
mount socket is provided on the top of the TL-1500,
TL-1550 and TL-1800 low frequency enclosures to
accept the PA-100 pole.
All TL series cabinets, including low frequency enclosures, can be rigged in permanent
installations using optional M10 shoulder eyebolts
optional M10 shoulder eyeboltsoptional M10 shoulder eyebolts
optional M10 shoulder eyebolts. The top of the cabinet is provided with two
internal threaded rigging points, and a further rigging point is provided on the back panel, below
the connector plate, used to determine the amount of downward angle. As supplied, these rigging
points are fitted externally with M10 countersunk bolts. To facilitate rigging of the enclosure
simply remove these M10 bolts and replace them with M10 x 18mm shoulder eyebolts using a
suitable thread locking compound to avoid the possibility of loosening (please refer to Appendix
C: Use of thread locking compounds at the back of this manual). Note:
Note: Note:
Note: Eyebolts must have a
thread length of at least 18mm (3/4”).