Filter
Top Products
user manual
TL series
TL series manual
page 13
MAINTENANCE
If any of the drive units in your TL series cabinet should cease functioning and need a replacement
recone or diaphragm, you are advised to remove the faulty unit from the cabinet and send it to a
professional service centre authorised to recone and repair Turbosound loudspeakers.
Removal of the low frequency driver(s)
The perforated steel loudspeaker grille is held in place under tension only, fitting into slots at
either side of the baffle. There are no screws or other fixings holding the grille in place.
1. Lay the cabinet on its back and, using two small screwdrivers inserted through the mesh of
the grille, firmly pull the grille away from the slot at one side of the baffle until it is free. Set
the grille aside for later re-assembly.
2. Undo the four screws holding the driver(s) in place and carefully lift it out and away from the
cabinet. Make a note of the driver polarity for later reconnection. Disconnect the cables from
the drive unit and completely remove the driver from the cabinet.
3. To reinstate the driver(s) simply reverse the above procedure, making sure you observe the
correct polarity when reconnecting the cables back into the terminals of the drive units.
Removal of the mid frequency driver
1. Remove the loudspeaker grille as described above and set the grille aside for later re-fitting.
2. Undo the four screws holding the driver(s) in place and carefully lift it out and away from the
cabinet. Make a note of the driver polarity for later reconnection. Disconnect the cables from
the drive unit and completely remove the driver from the cabinet. To reinstate the driver
simply reverse the above procedure, making sure you observe the correct polarity when
reconnecting the cables back into the terminals of the drive units.
Removal of the high frequency compression driver
1. Remove the loudspeaker grille as described above and set the grille aside for later re-fitting.
2. Remove the horn/driver assembly by unscrewing the four screws holding the flange in place.
Lift it out and away from the cabinet.
3. The high frequency driver can now be disassembled from the HF horn.
4. To reinstate the high frequency horn and compression driver, simply reverse the above
procedure making sure you observe the correct polarity when reconnecting the cables back
into the terminals of the drive unit.