Filter
Top Products
user manual
LMS-D24/26
LMS-D2X user manual
Page 10
• Edit Select Buttons – the currently selected edit parameter is displayed on the bottom left
corner of the LCD. Pressing the edit select buttons moves through the available
parameters for the current input or output.
• Text display – preset, channel, parameter and status information is shown on the 2x 24-
character text display. In most screens the currently selected channel is displayed on the
upper line and the edit parameter on the lower line. To simplify the display and enhance
security, some parameters or parameter pages are omitted when not relevant.
• Parameter Knobs – three velocity sensitive parameter knobs are used to adjust
parameters shown on the display. Up to three parameters are displayed on the screen.
The parameter name is shown above the parameter value in each of the three screen
sections. The parameter knobs have a fixed association with the screen sections; the
rightmost parameter knob adjusts the rightmost parameter and so on.
• Output signal and limiter indication – two LED’s are provided for each output channel.
These show the signal level relative to the limiter threshold. The yellow LED will light
when the signal is 6dB below the threshold and the red warning LED will light when the
limiter threshold is reached.
• Mute buttons and status LED’s – each output has a mute button and associated mute
status LED. Pressing the button toggles the mute on and off.
•
Note that the mute buttons do not function when the Secure Mode is activated.
• Secure Button (on the rear) – a momentary button is fitted behind the rear panel,
between the output XLRs and the RS232 port. When activated, this will disable all the
front panel controls so they cannot affect the signal path, making the unit secure against
tampering. When in secure mode, the indicators still operate normally.
Note that the communications port is still active in secure mode.