Filter
Top Products
19
10.3. Mounting the Enclosure to the Rigging Frame
Flying Plates are mounted to the front and rear of the enclosure’s sides. Follow the procedures below to
mount the enclosure to the Rigging Frame, as shown in the assembly diagrams.
Fix a supplied Joint Plate securely to the right side of the Rigging Frame, and another Joint Plate to the left
side of the enclosure, each using 4 supplied bolts with plain washers and spring washers. Before securing the
Joint Plate, determine whether the enclosure’s horn will face right or left. (This is not required for the SR-A18B
Subwoofer). When stacking the subwoofer, install the system so that the subwoofer is positioned at the
bottom (directly above the Rigging Frame).
High box assembly diagram Subwoofer assembly diagram
Join the enclosure to the Rigging Frame securely, using 4 supplied bolts with plain washers and spring
washers on each side (see the assembly diagrams below). For selecting holes in the Joint Plate to be used,
refer to the section “10-6 Tilting the enclosure downward” described later .
High box finished assembly diagram
(Left side) (Right side)
(Left side) (Right side)
Subwooter finished assembly diagram