Filter
Top Products
English
8. ALARM:
A. To set the Alarm time: Press the Alarm button briefly. The word “Alarm” will flash on the display.
(Figure 5) Press and hold the Time Set Button to set the Alarm time until a beep is heard to
confirm you have entered the Alarm Time Set mode. The hour will blink. (Figure 6) Tune Up/
Down buttons briefly to change each hour or press and hold to rapidly change the hours.
“PM” will appear for afternoon/evening hours but there is no “AM” designation for morning
hours. Now press the Time Set button to adjust the minutes using the Tune Up/Down buttons.
(Figure 7) The minutes will not affect the hour setting. Press the Time Set button again to save
the settings.
NOTE: Non-US models use a 24 hour alarm format.
Figure 8 Figure 9
B. To set the Alarm to wake: Set the SongBook to the FM or AM station you wish to wake to
and that will be broadcasting during the time you wish to wake (or set to Off or Aux to wake
to an increasing beep) and adjust the volume level accordingly. Press and hold the Alarm
button. A beep tone will be heard confirming the Alarm is set to wake and the word “Alarm”
will show on the display. The SongBook will go into Standby mode and the display will show
“Standby”. (Figure 8) If the Alarm has been set and the SongBook is in the Off position, the
alarm wake time will show in the upper right hand corner. When the alarm activates, the LCD
will light up and the word “Alarm” will flash. (Figure 9) Should you opt to wake to the beep,
the beep will sound for 60 seconds, then pause for 60 seconds, then resume for another 60
seconds. This pattern will repeat for up to one hour or until the Alarm button is pressed.
If the alarm is set and activates but the batteries are too weak to play the radio, the beep will
sound instead, provided there is enough battery power remaining. The LCD will show an “E”
to indicate the batteries are empty. (Figure 8)
Figure 10
C. To Cancel the Alarm: When the alarm activates, press the Alarm button to cancel the alarm
and the word “Alarm” will disappear from the display, the display will flash the word “Off”(Figure
10) for several seconds, and the unit will go into Standby. Changing the source knob to another
position will cancel Standby mode. Once the alarm activates, if it is not manually turned off, the
Alarm will shut off automatically after approximately 60 minutes to preserve the batteries and
the display will say “Standby”.
6