Filter
Top Products
Sleep To Music Timer
You can program the Sleep Timer to play the radio from 1 minute up to 99 minutes and then shut off automatically.
1. Press the SLEEP button. The display will briefly show “60” and the radio will begin to play.
After 60 minutes the radio will shut off automatically. Each time you press the SLEEP button
the sleep timer will start at 60 minutes. This is the initial sleep timer default setting.
2. To increase or decrease the amout of time that the radio will play before shutting off, hold the sleep button and press
either the SET� or � buttons to change the display to the desired sleep time, up to a maximum of “99” minutes or a
minimum of “1” minute.
Note: When you change the sleep timer from the 60 minute default setting to a different setting, the new setting becomes
the new default setting. Whenever you activate the sleep timer it will begin with your new default setting and count down to
zero from that point.
3. To cancel the sleep timer before it counts down to “0” and shut the radio ‘Off’ immediately, press the SNOOZE bar.
IMPORTANT: Remember that the station and volume settings that you choose for the “Sleep To Music” operation are the
same settings that you will hear if you set the alarm for wake to radio the following morning.
Display Dimmer Control
You can reduce the display brightness by sliding the DIMMER control to the Low position.
Line Input Jack
You may listen to the sound from an iPod, MP3 player, CD player or other external music source by connecting the external
device to the Line In jack on the back of this clock radio. Use an audio cable (not included) with 3.5mm mini plugs to connect
the headphone jack of the external device to the Line In jack of this unit. An AUX indicator will appear on the display when a
cable is connected to the Line In jack of this radio. Begin playback on the external device and adjust the VOLUME control of
this clock radio.
Note: You must remove the audio cable from the Line In jack of this clock radio in order to listen to AM or FM. When the
audio cable is disconnected the AUX indicator turns ‘Off’ in the display.
When the back-up battery voltage drops below a certain level the Low Battery indicator ( ) begins flashing in the display.
When you see this indicator you should replace the battery as soon as it is convenient for you to do so.
To replace the battery, proceed as follows:
IMPORTANT: Leave the radio connected to the AC outlet when replacing the battery to avoid losing all of your time and
alarm settings.
1. Purchase a replacement 3V lithium battery. The battery type is CR2450. This type battery is
available almost everywhere that batteries are sold.
2. Remove the battery from the packaging so it is ready to install.
3. Place that radio face down on a towel or similar soft surface to avoid scratching the front
lens.
4. Use a small Phillips screwdriver to remove the screw that secures the battery holder and
slide the battery holder out of the cabinet.
9
Battery Compartment
Changing The Lithium Back-Up Battery