Filter
Top Products
The Alarm Clock operates on 3 “AA” (R6) batteries,
which ar
e included is for demo purpose only. To replace
or install the batteries, follow these instructions:
Install The Battery:
1. The battery compartment is located on the back
of the cabinet. Open the battery compartment
door by screw driver then take out the battery
box.
2. Install 3 “AA” (R6) batteries, making sure that the
positive and negative polarities match up with
the diagram inside the battery box.
3. Put back the battery box into battery
compartment gently and in correct direction.
4. .Close the battery compartment door by screw
driver. Do not over-tighten.
For the Best Possible Performance:
• We recommend using alkaline batteries.
• Non-rechargeable batteries are not to be
recharged.
• Rechargeable batteries are to be removed from
the clock before being charged (if removable).
• Different types of batteries or new and used
batteries are not to be mixed.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Remove exhausted batteries from the clock.
• The supply terminals are not to be short-circuited.
• Rechargeable batteries are only to be recharged
under adult supervision. (if removable)
• Batteries are to be inserted with correct polarity.
Note: While pressing either FWD or
REV Button
the minutes will begin at a
moderate pace, then get faster. This will
assist you in setting the time both fast and
exact.
3. Press either the FWD or REV Button
repeatedly until the correct time is displayed.
Setting Alarm Time
1. Press and hold the Alarm Set/Reset
Button for several seconds until the display
flashes. If no alarm-set buttons are pressed
within approx. ten seconds, the display will
stop flashing and return to normal mode.
2. Press and hold the FWD Button to rapidly
advance the alarm time forward, or the
REV Button to rapidly change the alarm
time backward. Release button when the
approximate alarm time is displayed. PM
Indicator is on the lower right of the
display. Again, be sure to set the proper
AM or PM wake time as shown by PM
Indicator.
3. Press either the FWD or REV Button
repeatedly until the desired alarm time is
displayed.
4. When the alarm time has been set, press
the Alarm Set/Reset Button again to
return to the default clock display.
Front of Clock
Installing the Batteries
All of the clock and alarm functions are controlled
using the buttons in the fr
ont of cabinet (see graphic)
Setting Clock Time
1. Press and hold the Time Button for several
seconds until the display flashes. If no time-
set buttons are pressed within approx. ten
seconds, the display will stop flashing and
return to normal mode.
2. Press and hold the FWD Button to rapidly
advance the time forward, or the REV Button
to rapidly change the time backward. Release
button when the approximate correct time is
displayed. PM Indicator is on the lower right
of the display.
Setting Clock Time and Alarm Time
Operating the Alarm
Turning On the Alarm
1.
After setting the alarm time, set the Mode
Switch to Alarm ON to turn on the alarm.
The Alarm ON Indicator Icon will appear
on the display, showing that the alarm is
turning on.
2. Set the Volume Switch to Hi for louder
alarm sound and shaking effect during
alarm sounding. Set to Low for lower alarm
sound and no shaking effect.
Turning Off the Alarm
1. After the alarm sounds, press the Alarm
Set/Reset Button to turn it off and
automatically reset it for the same time the
following day.
Alarm Set/
Reset Button
FWD Button
REV Button
Time Button
Snooze/Light Button
Battery Installation
Volume Switch
Mode Switch
TIME SET
REV
ALARM ON
ALARM SET / RESET
FWD