Filter
Top Products
8
ADJUSTING THE VOLUME
To listen to FM radio:
Switch on the power by pressing the • STANDBY button.
If FM mode is not selected, press the • SOURCE button
repeatedly until ‘TUNER’ appears on the display.
The tuned frequency is displayed with stereo or mono
indication.
To tune to a station:
The radio is tuned from the remote control.
You can choose to tune automatically to the next station in
the band, to tune manually or to scan the band for stations
automatically and store those found in preset locations (auto
programming).
Tuning automatically:
Press and hold the • ] or [ button to scan up or down
the band.
The radio will scan the band and stop at the next station.
Tuning manually:
Press the • ] or [ button briey to step up or down the
band manually.
The radio will tune the band in 50kHz steps.
Auto programming:
Press the • SCAN button to automatically program the
radio presets.
The radio will tune the band and store each station found in a
preset location. This process may take a few minutes and will
erase stored presets. The preset stations can then be recalled.
STEREO/MONO SELECTION
To change between stereo and mono reception, press the •
/, button.
The display will show stereo or mono indication.
SELECTING A SOURCE
To increase the volume:
Press the • VOL+ button.
To decrease the volume:
Press the • VOL- button.
While the volume is being adjusted, the display will switch to
show the volume setting on a scale of 0-30.
You can choose to play music from FM radio (TUNER), a docked
iPod or a personal audio player or other source connected to
the AUX input on the rear panel.
To select a source:
Press the • SOURCE button to cycle through the sources.
The selected source (TUNER, iPod or Aux) will be shown on the
front panel display.
NOTE:- The iPod source option will only appear for selection
when an iPod is docked.
LISTENING TO FM RADIO
Radio presets
Your radio can store up to 20 of your favourite stations as
presets for quick recall.
Station presets are stored from the remote control.
To store a preset
Tune to the station you want to store as a preset.•
Press the • MEMORY button.
The ‘MEM’ symbol will ash on the display.
PRESET STATIONS
Press the • } or { button to locate the preset number
you want to store.
Press the • MEMORY button to store the preset.
The station will be saved and the ‘MEM’ symbol will stop
ashing..
NOTE: You can choose a preset number that is already in use.
The new station details will over-write the stored station.
To recall a preset
When playing FM radio, press the • } or { button to step
through the preset stations.
Each preset station will tune and the frequency will be
displayed.