Filter
Top Products
CENTRE CHANNEL
How to wall mount
WARNING: It is your responsibility to ensure that the bracket to wall fixing screws or
bolts and the walls themselves are strong enough to support the weight of the speaker
- refer to the speaker weight specifications supplied in this manual. Particular care is
needed when fixing to hollow or cavity walls - ‘'stud’' walls. Use only professionally
recommended fixing devices which will spread the load of the brackets and fixing screws
over an area of the wall surface when mounting to cavity walls. Pay particular attention
to the possibility of electrical cables and gas or water pipes which may be present in the
wall cavity or buried in the wall surface. Use a special cable or metal proximity locator
to locate these obstacles if in any doubt.
Before wall mounting the centre wall bracket, ensure sufficient clearance to hook the
speaker onto the bracket (approx half the speaker length to the left or right of the bracket).
Use a spirit level to ensure the bracket is fitted level.
Mount the bracket on the wall with a suitable fixing (not supplied - see warning note).
Using the 8mm screws and washers provided attach the two small brackets to the fixing
points. Ensure that the bracket with pre fitted cap has the cap facing outwards, on the
side you have left clearance for hooking onto the wall .
Thread the speaker wire through the spare cap.
Important note: It is essential that the speakers are wired correctly at this stage.
The (-) wire should have a solid black line or similar marked along it.
Screw the (+) wire into the red terminal and screw (-) wire into black terminal.
11