Filter
Top Products
WAKE TO RADIO
Having selected your station and set the volume at the desired level, proceed as
follows:
1. Slide the ON/OFF/AUTO Switch (1) to 'AUTO' position.
2. Turn the switch (4) to "Set Alarm" position, and then press the Hour Button (6)
until the hour is reached at which you wish to wake.Then press Minute Button (5)
to set alarm minute. After setting the alarm time, turn the dial (4) back to "clock"
position. The wake up time is now entered into the timer memory. To check the
wake up time, simply turn the dial (4) to "Set Alarm" position, and the clock will
show the time the alarm is set for. The wake up time will remain in the timer
memory and the radio will switch on by itself at the same time the next day. To
switch the radio off, simply slide the On/Off/Auto(1) Switch to 'Off' position.
Please note that the Alarm On indicator (14) is illumanated when alarm is set to
operate.
WAKE TO BUZZER
Set the controls as for 'Wake to Radio' but turn the Volume Control (12) back until
it clicks into BUZZER position. The buzzer can be turned OFF or sound switched to
the radio by selecting switch (1) to OFF or ON position.
SLEEP TO MUSIC
The radio can be set to play and to switch off automatically for a length of time from
1 minute to 1 hour 59 minutes by following this procedure. With tuning and volume
controls set,Place ON/OFF/AUTO switch (1) in the AUTO Position. Then depress
the Sleep Button (2) and press the Minute Button (5) to count down to the desired
sleep time. To switch off the radio before the end of the registered sleep time period,
simply press the Snooze Button (3).
SNOOZE CONTROL
Pushing down on the Snooze Button (3) turns the alarm sound off and allows the
user extra sleep time of about 9 minutes.This can be repeated as often as you like
for up to 2 hours.Turn ON/OFF/AUTO switch (1) to OFF to stop Snooze function.
BATTERY BACK-UP
Connect a 9 volt battery (not included) to the terminals inside the battery compart-
ment on bottom of clock radio. It is recommended that the set be disconnected
from the 110/120V power source while the battery is fitted. The clock display will not
light up, but the clock time will be held in the clock memory by the battery back-up
system. This enables you to move the set from place to place without re-setting the
clock every time. The battery back-up system is only meant to be used from short
temporary power failures. For longer durations the battery may become exhausted
or there may be some deviation in accuracy,due to the battery being exhausted. It
should be removed from the set to prevent leakage. If you do not wish to take
advantage of the battery back-up system, your set will work normally without a
battery. However, if disconnected from the 110/120V source, the clock display will
flash when the power is re-connected and you must re-set the clock as described in
the Electronic Clock Operation paragraph.