Filter
Top Products
SLEEP TO MUSIC
The radio can be set to play and to switch off automatically for a length of time from 1
minute to 1 hour 59 minutes by following this procedure
-
With all the controls pre-set in
the “Wake to Radio” positions, depress-the
Sleep Button and Press the Minute
Button to
count down to the desired sleep time. To switch off the radio before the end
of the
regis-
tered sleep time period, simply press the Snooze Button.
SNOOZE CONTROL
The snooze button allows the user extra sleep time of about 9 minutes after the alarm is
switched on at the pre-set wake up time.
BATTERY BACK-UP
(For Temporary Time Storage Only)
Connect a 9 volt battery (not included) to the terminals inside the battery compartment.
It
is recommended that the set is disconnected from the main power supply while the battery
is fitted. Your set will not work normally from the main power supply but there is now the
advantage that if there is a main power current failure, your clock will continue to work. The
clock display will not light up, as the clock time will be held in the clock memory by the
battery back-up system. This enables you to move the set from place to place without re-
setting the clock every time. The battery back-up system is only meant to be used for short
temporary power failures. For longer durations, the battery may become exhausted or there
may be some deviation in accuracy. When the battery is exhausted, it should be removed
from the set to prevent leakage. If you do not wish to take advantage of the battery back-up
system, your set will work normally without a battery. However, if disconnected from the
main power supply, the clock figures will flash when the main power supply is re-connected
and you must re-set the clock as described in the Electronic Clock Operation paragraph.
GENERAL CARE
The cabinet can be cleaned with a slightly damp cloth (make sure the cord is disconnected
from main power supply).
Avoid leaving the clock radio in direct sunlight or in hot, humid, dusty places. Keep the set
away from heating appliances and electrical generated noises, such as fluorescent lamps or
motors.
Warning: Changes or modifications
to
this
unit
not expressly approved by
the
party responsible for compliance could void the user’s
authority
to operate
the equipment.