Filter
Top Products
The Timer 33
The Timer
5 Set the timer to the hour and the minutes you want
to start recording.
1 Press TUNING
TIME SET + or – to set
the hour and press
ENTER•MEMORY
CHECK.
2 Press TUNING TIME SET + or – to set the
minutes, and press ENTER•MEMORY
CHECK.
6 Set the timer to the hour and the minutes you want
to stop recording. (Do as step 5.)
7 Press TUNING TIME SET
+ or – to set the volume
you want, and press
ENTER•MEMORY
CHECK.
8 Press STANDBY.
The power goes off and the player enters the
standby mode. The t indication and the recording
side of the tape (upper side ( or reverse side
9) appear in the display. If the 9 indication
appears, press STANDBY to change the recording
side to ( .
At the preset time, the power will go on and the
recording will start. Then the power will go off at
the preset time, and the player will enter the
standby mode again.
To check/change the recording timer settings
Press TIMER, then ENTER•MEMORY CHECK. Each
time you press ENTER•MEMORY CHECK, a stored
setting is displayed in the set order. To change the
setting, display the setting you want to change and
re-enter it.
To use the player before a timer-recording starts
If you turn on the player, you can use it as usual.
Before the preset time, tune in the station you want to
record and turn off the power.
To stop timer-recording
Turn off the power.
Tip
If you made a mistake,
press CANCEL. The
setting entered last will
be cleared. Re-enter it.
Tips
• To exit the standby
mode, press STANDBY
twice to make the t
indication disappear.
• The preset settings
remain until you reset
them.
• When you select both
sides recording, the
recording will stop
after the both sides
recording finishes so
that accidental
recording will not be
made.
• The display window
does not light while the
recording timer is on.